Using Spinal Molding Supports

	Log In Cart Contents Checkout

Products

The Kare Spinal Molding Supports re-trains the spine and muscles thus restoring the natural curvature of the spine.These tools are used by the patient while lying on a flat surface (not a bed) for 5 to 30 minutes. The spinal rehabilitative exercises explained below will provide a gentle spinal traction and stretch the ligaments. These simple stretches may help improve your posture and reduce tension that you may be experiencing from mis-alignment.You should use the supports for 5 to 30 minutes as prescribed by your doctor.


Figure 1. Place the Cervical Traction Fulcrum under the neck with the slanted side supporting the head. The Lumbar Half Roll is placed under the lower back (lumbar) to relax and enhance lumbar curve. Place Block/Wedge under the pelvis to flatten the lower back and to aid in the correction of improper pelvic tilt.	Figure 2. Place the Cervical Traction Fulcrum under the neck with the slanted side supporting the head. The Lumbar Half Roll placed under the lower back (lumbar) to relax and enhance lumbar curve.


Figure 3. Place the Cervical Traction Fulcrum under the neck with the slanted side supporting the head. The Block/Wedge under the pelvis to flatten the lower back and to aid in the correction of improper pelvic tilt.	Figure 4. Place the Cervical Traction Fulcrum under the neck with the slanted side supporting the head.